RainWater Harvesting Filter
V-Wire Screen
Installation Sites
RainySystem ZPE/KonkanRailways
'V'Wire Injection Well
   
 
TroubleShooting
 

Problems Solutions

When less discharge through the clean water outlet and more discharge of water through the drain water outlet.

  • .

Open the filter cap and check if there is any blockage in housing or filter element. incase of any blockage of housing or filter element, clean the same.

In low operating pressures, asbestos sheet rooftop and in dust prone areas frequent cleaning of filter element is advisable.

Check the filter element (SS-304). In case of clogging remove the same and wash it with garden hoseor under the tap, clean it up with a brush. After the wash and proper cleaning Re-insert the filter and tighten the filter cap and start operating the system. Clean the filter element periodically to avoid clogging.

 

During water logging on rooftop/ insufficient discharge to the filter INLET.

There might be chances of blockage at entry point of rooftop rain inlet pipe blockage in the elbows or joints of Rainwater pipeline connections, blockage at filter entry point, blockage in the horizontal pipeline, blockage in Drain outlet, improper selection of pipe diameter, etc. Check all the above parameters, clean the rooftop, remove the blockage, repair and re-fit the pipeline and test the system for free flow

 

 

 

 

 

Copyright 2008, Farmland, all rights reserved. Developed By Overtake Software Technologies Ltd